# Installing the USB device driver

Install the following software will automatically install Open Debugger driver。

**CC Debugger：**

SmartRF Studio [www.ti.co](http://www.ti.co) m/tool/smartrftm-studio

SmartRF Flash Programmer [www.ti.com/tool/flash-programmer](http://www.ti.com/tool/flash-programmer)

SmartRF Packet Sniffer [www.ti.com/tool/packet-sniffer](http://www.ti.com/tool/packet-sniffer)

PurePath Wireless Conf igurator [www.ti.com/tool/purepath-wl-cfg](http://www.ti.com/tool/purepath-wl-cfg)

PurePath Wireless Commander [www.ti.com/tool/purepath-wl-cmd](http://www.ti.com/tool/purepath-wl-cmd)

**SWD：**

JLinkARM [www.segger.com/jlink-software.html](http://www.segger.com/jlink-software.html)

**JTAG/USB2UART：**

Uniflash [www.ti.com.cn/tool/cn/uniflash](http://www.ti.com.cn/tool/cn/uniflash)

When all the device drivers installed successfully will be shown below：

![](/files/-M2HX-XOms3d9usXH-ux)


---

# Agent Instructions: Querying This Documentation

If you need additional information that is not directly available in this page, you can query the documentation dynamically by asking a question.

Perform an HTTP GET request on the current page URL with the `ask` query parameter:

```
GET https://bananapi.gitbook.io/bpi-open-debugger-burn-board/en/installingtheusbdevicedriver.md?ask=<question>
```

The question should be specific, self-contained, and written in natural language.
The response will contain a direct answer to the question and relevant excerpts and sources from the documentation.

Use this mechanism when the answer is not explicitly present in the current page, you need clarification or additional context, or you want to retrieve related documentation sections.