# Installing the USB device driver

Install the following software will automatically install Open Debugger driver。

**CC Debugger：**

SmartRF Studio [www.ti.co](http://www.ti.co) m/tool/smartrftm-studio

SmartRF Flash Programmer [www.ti.com/tool/flash-programmer](http://www.ti.com/tool/flash-programmer)

SmartRF Packet Sniffer [www.ti.com/tool/packet-sniffer](http://www.ti.com/tool/packet-sniffer)

PurePath Wireless Conf igurator [www.ti.com/tool/purepath-wl-cfg](http://www.ti.com/tool/purepath-wl-cfg)

PurePath Wireless Commander [www.ti.com/tool/purepath-wl-cmd](http://www.ti.com/tool/purepath-wl-cmd)

**SWD：**

JLinkARM [www.segger.com/jlink-software.html](http://www.segger.com/jlink-software.html)

**JTAG/USB2UART：**

Uniflash [www.ti.com.cn/tool/cn/uniflash](http://www.ti.com.cn/tool/cn/uniflash)

When all the device drivers installed successfully will be shown below：

![](https://1339817493-files.gitbook.io/~/files/v0/b/gitbook-legacy-files/o/assets%2F-M2HWtRMO1SOVoE1wKC5%2F-M2HWuqfjq-tAqyjGf2g%2F-M2HX-G3siX3WO1kigoO%2Fdebug%201.png?generation=1584080153975078\&alt=media)