banana pi BPI-D1 open source IP camera
  • Initial page
  • LANGS
  • Banana pi BPI-D1 open source IP camera project.
    • View Real-time Video
    • BPI-D1 Power Supply
    • Summary
    • How to connect to the AP
    • How to record a video
    • How to set
    • BPI-D1 hardware interface
    • BPI-D1 GPIO Pin define
    • BPI-D1 hardware spec
    • All banana pi product
    • bpi40customizedserver
    • Program the Firmware
    • How to view files
    • BPI-D1 source code on github
    • First Chapter
    • Relevant Information
    • BPI-D1 schematic diagram
    • AK3918 Specification
  • Banana pi BPI-D1 open source IP camera project.
    • First Chapter
    • How to connect to the AP
    • Summary
    • How to record a video
    • BPI-D1 hardware interface
    • How to set
    • BPI-D1 GPIO Pin define
    • BPI-D1 hardware spec
    • BPI-D1 source code on github
    • Relevant Information
    • BPI-D1 schematic diagram
    • AK3918 Specification
    • View Real-time Video
    • Program the Firmware
    • BPI-D1 Power Supply
    • How to view files
Powered by GitBook
On this page

Was this helpful?

  1. Banana pi BPI-D1 open source IP camera project.

How to connect to the AP

PreviousFirst ChapterNextSummary

Last updated 5 years ago

Was this helpful?

Connect to the specified AP

The USB-WiFi module is connected to the USB interface of OTG. Press the BPI-D1 "primary key" button, green LED will keep long bright after flashing about 8 seconds; it means BPI-D1 work in AP mode.

  1. Connect any mobile devices (e.g. Smartphone, tablet or computer) to the WiFi connection “SSID= XXX_D1_A39XXX” and enter the default password “12345678”.

  2. In Internet Explorer, enter the FTP address “ftp://192.168.0.1”. (user name: admin, password: admin)

  3. Click "Ethernet”, select one of the available WiFi. The SSID parameter will be displayed in the above, click password blank and enter the known password, then click the "save". After flashing on the screen, four parameters in the form disappeared that the connection is successful.

  4. Click on the (39) Boot/WPS button, BPI-D1 switches to slave mode; you will see LED flashes from fast into slow, which has been connected to the specified WiFi-AP.