BPI Open debugger burn board
  • Initial page
  • LANGS
  • BPI Open debugger burn board
    • BPI Open debugger burn board Abbreviations
    • Summary
    • Connection CC Debugger and CC85xx
    • Download the program using the SWD in J-Flash
    • Open Debugger Uart use of STC microcontroller programming interface
    • Operating condition
    • Supported PC Tools
    • Open Debugger CC Debugger module functions in use
    • Use SmartRFProg tools to program the CC series chips
    • SWD Interface：
    • Installing the USB device driver
    • Download SWD debug using the IAR EWARM
    • Use SWD debug download the MDK-ARM
    • CC Debugger Interface：
    • CC-Debugger connection and Transceivers Transceiver
    • MDK-ARM SWD interface in single-step debugging
    • Use Uni flash via JTAG and UART interface to TI CC3200 in the curing process
    • SWD interface IAR EWARM single-step debugging
    • CC- Debugger connected to the SoC device
    • CC Debugger LED light
    • Reference
    • SWD interface device connected to the SOC
    • UART Interface：
    • JTAG/Uart Interface：
    • CC Debugger firmware update
  • BPI Open debugger burn board
    • SWD interface device connected to the SOC
    • Reference
    • UART Interface：
    • JTAG/Uart Interface：
    • Use SmartRFProg tools to program the CC series chips
    • Summary
    • Supported PC Tools
    • Connection CC Debugger and CC85xx
    • Installing the USB device driver
    • Download SWD debug using the IAR EWARM
    • Use SWD debug download the MDK-ARM
    • Download the program using the SWD in J-Flash
    • use-steps
    • Open Debugger Uart use of STC microcontroller programming interface
    • Operating condition
    • All banana pi product
    • Open Debugger CC Debugger module functions in use
    • bpi40customizedserver
    • SWD Interface：
    • connect-the-emulator-and-target-board
    • CC Debugger LED light
    • CC Debugger Interface：
    • support-objects
    • CC-Debugger connection and Transceivers Transceiver
    • MDK-ARM SWD interface in single-step debugging
    • Use Uni flash via JTAG and UART interface to TI CC3200 in the curing process
    • SWD interface IAR EWARM single-step debugging
    • CC Debugger firmware update
    • BPI Open debugger burn board Abbreviations
    • CC- Debugger connected to the SoC device
Powered by GitBook
On this page

Was this helpful?

  1. BPI Open debugger burn board

Open Debugger CC Debugger module functions in use

PreviousSupported PC ToolsNextUse SmartRFProg tools to program the CC series chips

Last updated 5 years ago

Was this helpful?

After CC Debugger interface to connect to the target device, you need to press the reset button next to (see below), it will automatically find all known devices. If you do not detect the device, LED will turn red. If the device is detected, LED will be green. If the LED is green, indicating that you can be able to meet the PC side software use。

Note：that only when the status light is green CC Debugger to debug and download work, if it is red, please press the reset button, and check the connection with the target chip, until the status light turns green。